Why would that be a problem? As long as you don't issue any HS-mode instructions or touch any of the hypervisor CSRs then any code should run the same.

Jonathan

On Wed, Jun 3, 2020 at 2:51 PM Greg Favor <gfavor@...> wrote:

One issue is that the current Privileged spec requires that misa.H is reset to '1' if the Hypervisor extension is implemented.  Unaware boot code will leave that set and then problems will ensue later.

Greg

On Wed, Jun 3, 2020 at 11:46 AM Jonathan Behrens <behrensj@...> wrote:

I would expect the rule be that either the reset state properly initializes all the H-extension CSRs or the boot code. Thus if you want hardware to be backwards compatible with legacy boot code, you just have to make sure the reset state is correct. And if you don't care about backwards compatibility then you have the flexibility to not worry about the reset state and just configure things in the boot code.

Jonathan

On Wed, Jun 3, 2020 at 2:31 PM Greg Favor via lists.riscv.org <gfavor=ventanamicro.com@...> wrote:

We have run across the situation of running "legacy" (i.e. current) boot code that naturally is unaware of the possible existence of the Hypervisor extension.  Since, on a platform that does implement the Hypervisor extension, misa.H is required to be reset to '1', there are architectural behavior changes that can trip up this boot code.  Both because the hypervisor extension is enabled and because new CSR's (some of which contain bits that, for example, affect the behavior of existing instructions) will remain uninitialized by this unaware boot code.

We suspect that the following is the view by the architecture:

Boot code that may run on platforms that may or may not support certain arch extensions (such as the Hypervisor extension) must be aware of their potential existence and be prepared to deal with misa indicating that they are or are not supported.

Conversely, unaware "legacy" boot code is not expected or required to run as-is on newer platforms that support newer arch extensions.  Such "old" boot code must be ported to run on platforms that implement new architecture extensions like the Hypervisor extension.  

Yes?

Greg